Kamera - Kleines Stativ

A small tripod to which tripod rods up to 50 cm in length can be reliably attached by means of an adapter. In combination with our camera mount, it is suitable as a table tripod for cameras, webcams or even smartphones. The 2-axis mount shown in the picture, can be found here.

Download

All components were printed with 20% infill density, without supports and without adhesion layers. The models are oriented in such a way that this is not necessary. An adhesion layer was used during printing.

Accessories

• The 2-axis mount shown in the pictures is available here.

Component overview

Table stand

For the fully printed table tripod, consisting of tripod base and short rod, the following components must be printed:

• CameraMount-Base.stl (tripod base)
• CameraMount-Baserod.stl (short, screwable tripod rod. Length 35 mm / diameter 12 mm: 40% infill density)

With the help of our mount the table tripod can be extended to a universal camera mount.

Extension for tripod rods up to 12 mm diameter

If you want to attach tripod rods up to 12 mm diameter to the stand, you can do it with the help of the following adapter.

• CameraMount-BaserodAdapter.stl (screwable adapter: 40% infill denisty)

The adapter has two M4 threads where the rod can be locked by means of suitable screws (ideally M4x10). Depending on the use and load of the tripod, the base can be screwed to a solid wooden plate or similar for weighting.